Fargo-electronic C16 Bedienungsanleitung PDF herunterladen (Seite 191)

RESTRICTED USE ONLY Fargo Electronics, Inc.

Persona C16 Card Printer Service Manual (Rev. 5.0)

182

Replacing the Ribbon ID Sensor Board Assembly (820543)

Refer to Drawing D810024

Estimated Repair Time: 30 minutes.

Steps Procedures

Caution: Turn off the Printer and unplug the power cord from the

Printer.

2 Open the Upper Imaging Assembly.

3 Remove the top two corner screws (130987) found just behind the top edge of

the Front Cover.

4 Close the Upper Imaging Assembly.

5 Remove the screw (130987) by the Card Exit Ramp.

6 Remove the Front Cover

7 Remove the Retaining Ring (140009).

Use a replacement Retaining Ring when installing the new Ribbon ID Sensor

Board Assembly.

8 Extract the Right Ribbon Hub (763345) and the Clutch Spacer (760386) off of

the Hub Linkage Assembly (810115).

9 Move the Ribbon ID Sensor Board Assembly off of the Hub Linkage Assembly.

(Note: Take care not to misplace the Spring; it can remain on the Hub Linkage

Assembly.)

10 Loosen the top two corner screws (130987) found just behind the top edge of

the Rear Cover.

11 Close the Upper Imaging Assembly.

12 Remove the screw (130987) by the Card Exit Ramp.

Continued on the next page

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 258 259

Keine Kommentare

Fargo-electronic C16 Bedienungsanleitung Seite 191